Advertisement
Product dimensions
/+-3V
(762cm)
width
-W
height
Cabinet dimensions
30" (76.2cm) min. base cabinet
is required.
If cabinet has a drawer, a 3" (75cm) depth
clearance from the countertop to the top of
the drawer (or other obstruction)
in the base
cabinet is required.
30" (76.2cm) min. cabinet
h-width
above cooktop
16" (45.7cm)
f
For minimum
clearances,
see Note.*
I
13Lk+
4,
max. upper
cabinet
countertop.
25" (63.5cm)
countertop
depth
24" (61cm)
lower cabmet
depth
(30cm) or
more above
the floor
line.
min.
Note: 24" (61cm) min.
clearance
rf bottom of
wood or metal cabinet
is
protected
by not less than
l/4" (O&m)
flame
'/
retardant
millboard
covered
with not less than
/
No. 28 MSG sheet steel,
0.015" (0.04cm) stainless
steel, or 0.024"(0.06cm)
'
aluminum
or 0.020"
(OJXcm) copper.
30" (76.2cm) min.
clearance
between
top of
cooking
platform
and
bottom of unprotected
wood or metal cabinet.
Cutout dimensions
-Minimum
distance
to nearest left side
and rear combustible
surface
above
countertop
Before you start...
Proper installation
is your responsibility.
Make sure you have everything for correct
installation.
It is the responsibility
of the
installer to comply with the installation
clearances specified on the serial/rating
plate. The serial/rating
plate is found on the
bottom of the cooktop.
Cooktop
installed
over oven installation:
Cooktop models KECC500W, KECC500B,
YKECC500B
and YKECC500W
can be
installed over oven models KEBNl OOY,
KEBNlO7B and RB262PXA.
Check location
where cooktop will be
installed. The location should be away from
strong draft areas, such as windows, doors
and strong heating vents or fans. The
cooktop should be located for convenient
use in the kitchen.
Important:
Observe all governing
codes and
ordinances.
Failure to meet governing
codes and
ordinances
could lead to fire or electrical
shock.
Countertop
opening
dimensions
that are
shown must be used. Given dimensions
are
minimum clearances and provide required
0" (Ocm) clearance.
New installations
-follow
minimum
dimensions
given.
Replacement
installations
-
Be sure that
front edge of cooktop is at least l-1/2"
(3.8cm) back from front edge of countertop.
A built-under oven may be installed under
this cooktop if oven is approved for this type
of installation.
Check for approval label
located on top of oven. If label is not
located, contact dealer to confirm that oven
is approved. Refer to oven manufacturers
Installation
Instructions for approval and
proper cutout dimensions.
When installing
cooktop
over a built-
under oven, Do Not fasten cooktop to
countertop with clamps. Cooktop then will
be easy to remove if servicing is ever
necessary.
ALL OPENINGS
IN THE WALL OR FLOOR
WHERE THE COOKTOP
IS TO BE
INSTALLED
MUST BE SEALED.
Electrical
Shock Hazard
It is the customer's
responsibility:
l
To contact
a qualified
electrical
installer.
l
To assure that the electrical
installation
is adequate
and in
conformance
with National
Electrical
Code, ANSVNFPA 70 -
latest
edition**,
or Canadian
Electrical
Code, C22.1 - 1982 and C22.2 No.
01982 (or latest edition)*'*
and all
local codes and ordinances.
Failure to do so could result in
electrical
shock or other personal
injury.
Personal
Injury Hazard
Cabinet storage above the cooking
surface should
be avoided.
If cabinets
are already
installed,
reduce the
hazard of reaching
over a heated
cooking
surface
by installing
a range
hood.
The range hood should
extend a
minimum
of 5 inches out from the
bottom of the cabinets.
Reaching
over a heated cooking
surface could result in a serious
burn.
Copies of the standards listed may be
obtained from:
**National
Fire Protection
Association
Batterymarch
Park
Quincy,
Massachusetts
02269
***Canadian
Standard
Association
178 Rexdale Boulevard
Rexdale, (Toronto
), Ontario
M9W 1 R3
Panel A
Advertisement
