Installing A Memory Card; Installing A Sim Card - Honeywell Dolphin 99EX User Manual

Installing a Memory Card

1. Press the Power key
2. Release the hand strap hook near the speaker on the back panel of
the terminal.
3. Remove the battery door.
4. Wait at least 3 seconds, and then remove the battery.
5. Remove the T6 TORX
6. Lift up the lower left corner of the door to access the memory
socket.
7. Unlock the access door to the memory socket by sliding the door
toward the IrDA port side of the terminal.
8. Lift the door up to expose the socket.
9. Slide the microSD or microSDHC card into the door of the socket.
Note: Make sure the interface on the memory card is connected to the interface
in the socket; align the notch on the card with the notch of the socket.
10. Close and lock
11. Close the protective door over the memory socket. Install and
tighten the T6 TORX screw to secure the door closed.
12. Install the battery and the battery door. Reattach the hand strap to
the terminal.
13. Press the Power key or SCAN key to wake the terminal.

Installing a SIM Card

See Installing a SIM Card
to put the terminal in Suspend Mode.
®
screw securing the protective door closed.
the access door.
on page 9-4.
Step 5
Step 6
Step 7
Step 8
Step 9
Step 10
3 - 17