Components of the breakdown kit
Fig. 113 Components of the breakdown kit
ä
First read and observe the introductory information and safety warn-
ings
on page 132.
The breakdown kit contains the following parts:
Valve remover
1
Sticker with speed designation "max. 80 km/h"/"max. 50 mph"
2
3
Inflation hose with plug
Air compressor
4
Tyre inflation hose
5
Tyre inflation pressure indicator
6
Air release valve
7
ON and OFF switch
8
12 volt cable connector
9
Tyre inflator bottle with sealing agent
10
Replacement valve core
11
The valve remover
has a slot at its lower end which fits into the valve core.
1
This is the only way in which you can remove and re-install the valve core from
the tyre valve. The same also applies to the replacement valve core
Preparing to use the breakdown kit
ä
First read and observe the introductory information and safety warn-
ings
The following preparatory work must be carried out before using the breakdown
kit:
›
In the event of a puncture, park the vehicle as far away as possible from the
flow of traffic. Park on as flat and firm a surface as possible.
›
Let all of the occupants get out. While changing a tyre, the occupants of the
vehicle should not stand on the road (instead they should remain behind a crash
barrier).
›
Switch off the engine and move the gearshift lever into Neutral or move the
selector lever for the automatic gearbox into position N.
›
Firmly apply the handbrake.
›
Check whether you can carry out the repairs with the breakdown kit
Breakdown kit.
›
Remove the breakdown kit from the luggage compartment.
›
Stick the sticker
›
Do not remove the foreign body, e.g. screw or nail, from the tyre.
›
Unscrew the valve cap.
›
Use the valve remover
face (rag, paper, etc.).
Seal and inflate tyres
ä
First read and observe the introductory information and safety warn-
ings
Sealing tyres
›
Forcefully shake the tyre inflator bottle
›
Firmly screw the inflation hose
direction. The film on the cap is pierced automatically.
›
Remove the plug from the inflation hose
the tyre valve.
›
Hold the bottle
agent from the tyre inflator bottle into the tyre.
›
Remove the empty tyre inflator bottle from the valve.
.
11
›
Screw the valve core back into the tyre valve using the valve remover
on page 132.
» Fig. 113
on the dash panel in view of the driver.
2
to unscrew the valve core and place it on a clean sur-
1
on page 132.
» Fig. 113
10
onto the tyre inflator bottle
3
and plug the open end fully onto
3
with the bottom facing upwards and fill all of the sealing
10
» page
132,
several times.
in a clockwise
10
.
1
£
133
Do-it-yourself