Truma Cp Plus Digital Control Panel; Operating Instructions; Safety Instructions; Intended Use - Bailey Pursuit Owner's Manual

Truma CP Plus Digital Control Panel

Operating Instructions

Safety instructions

• The device may only be operated if it is in
perfect working order.
• Arrange for malfunctions to be rectified
immediately. Only rectify malfunctions
yourself if the remedy is outlined in the
troubleshooting information in these
Operating Instructions. These can be found
on page 86.
• Do not repair or modify the device.
• Only allow the manufacturer or its
customer service to repair a faulty device.
If the power supply to the system is
i
interrupted for longer than 20
minutes, the time and date need to be
entered again.
If the Truma Combi heater is connected to the
control panel Truma CP Plus, the heater can
no longer be switched via a ZUCB timer.

Intended Use

The control panel Truma CP Plus serves to
control and monitor a Combi heater and/
or a Truma air conditioning unit. The device
is designed for installation in caravans and
motor-caravans.
Display and control elements
1. Display
2. Status line
3. Menu line (above)
4. Menu line (below)
5. Display of mains voltage 230v (shore power)
6. Display timer
7. Settings/values
8. Control knob/push button
9. Back button
The control knob/push button (8) is used to
select menus in lines 3+4 and configure the
settings. These are shown via a display (1)
with a lighted background. Pressing the Back
button (9) takes the user back out of the menu
again.
Control knob/push button
The control knob/push button (8) is used to
select and change set values and parameters:
these can be saved by clicking the control
knob/push button. Selected menu items will
flash.
Clicking
Accept (save) a selected
value.
Select a menu item or
a change to the setting
level.
Press (3 seconds)
Main switch function ON/
OFF
Back Button
Pressing the Back button (9) takes the user
back out of the menu again and discards the
settings. This means that the previous values
are retained.

Functions

The functions in the menu lines 3 & 4 of the
control panel can be selected in any sequence.
The operating parameters are shown in the
status line (2) or the displays 5 and 6.
Turn to the right (+)
Menu is paged from left
to right.
Increase values.
Turn to the left (–)
Menu is paged from
right to left.
Reduce values.
83