Filter Sign Setting - Carrier MMK-AP0073H2UL Installation Manual

+001111053901_00Ta.book Page 22 Monday, January 17, 2011 11:35 AM
High Wall Type
2
Procedure
Each time button is pushed, indoor unit
numbers in the control group change cyclically.
Select the indoor unit to change settings for.
The fan of the selected unit runs and the louvers
start swinging. The indoor unit can be confirmed for
which to change settings.
3
Procedure
Specify CODE No. [
buttons.
4
Procedure
Select SET DATA [
buttons.
5
Procedure
Push button. When the display changes from
flashing to lit, the setup is completed.
• To change settings of another indoor unit, repeat
2
from Procedure .
• To change other settings of the selected indoor
unit, repeat from Procedure
Use button to clear the settings.
To make settings after
repeat from Procedure
6
Procedure
When settings have been completed, push
button to determine the settings.
When button is pushed, "SETTING" flashes
and then the display content disappears and the air
conditioner enters the normal stop mode.
(While "SETTING" is flashing, no operation of the
remote control is accepted.)
] with temp. setup /
] with timer time /
3
.
button was pushed,
2
.
– 22 –

Filter sign setting

According to the installation condition, the lighting
time of the filter sign (Notification of filter cleaning)
can be changed.
Follow to the basic operation procedure
1 2 3 4 5 6
→ → → → →
(
• For the CODE No. in Procedure
• For the [Set data] in Procedure
DATA of filter sign lighting time from the following
table.
SET DATA Filter sign lighting time
0000
0001 150 H (Factory default)
0002
0003
0004
To secure better effect of heating
When it is difficult to obtain satisfactory heating due
to installation place of the indoor unit or structure of
the room, the detection temperature of heating can
be raised. Also use a circulator or other device to
circulate heat air near the ceiling.
Follow to the basic operation procedure
1 2 3 4 5 6
→ → → → →
(
• For the CODE No. in Procedure
• For the set data in Procedure
DATA of shift value of detection temperature to
be set up from the table below.
SET DATA Detection temp shift value
0000
0001 +1.8 °F (+1 °C)
0002 +3.6 °F (+2 °C)
0003 +5.4 °F (+3 °C) (Factory default)
0004 +7.2 °F (+4 °C)
0005 +9.0 °F (+5 °C)
0006 +10.8 °F (+6 °C)
Installation Manual
).
3
, specify [01].
4
, select the SET
None
2500 H
5000 H
10000 H
).
3
, specify [06].
4
, select the SET
No shift
EN
22-EN