Canon PIXMA iP5300 Service Manual page 9

7 times Multiple ink tanks of the
same color installed. [1681]
Ink tank in a wrong
position. [1680]
8 times Warning: The ink absorber
becomes almost full. [1700]
9 times The connected digital
camera or digital video
camera does not support
Camera Direct
Printing. [2001]
10 times Automatic duplex printing
cannot be performed. [1310]
11 times Failed in automatic print
head alignment. [2500]
13 times The remaining ink amount
unknown. [1683]
14 times Ink tank not recognized.
[1684]
15 times Ink tank not recognized.
[1410 to 1414]
16 times No ink. [1688]
printing the remaining data for the ejected CD or
DVD, then the next print job will be performed.
Replace the wrong ink tank(s) with the correct one
(s).
Install the ink tank(s) in the correct position.
Press the Resume/Cancel button.
Remove the cable between the camera and the
printer.
Press the Resume/Cancel button to eject the paper
being used at error occurrence. Printing will resume
from on the front side of the next page.
Press the Resume/Cancel button.
- If paper is being fed at error occurrence, the error
is indicated after the paper is ejected.
- If the error occurs, the print head alignment values
are not changed.
- After exit from the error by the Resume/Cancel
button, the automatic print head alignment will
not be re-done.
Replace the applicable ink tank with a new one, and
close the scanning unit (printer cover).
Printing with a once-empty ink tank can damage the
printer.
To continue printing without replacing the ink tank
(s), press the Resume/Cancel button for 5 sec. or
longer to disable the function to detect the
remaining ink amount. After the operation, it is
recorded in the printer EEPROM that the function
to detect the remaining ink amount was disabled.
A non-supported ink tank is installed (the ink tank
LED is turned off). Install the supported ink tanks.
A hardware error occurred in an ink tank (the ink
tank LED is turned off). Replace the ink tank(s).
Each error code corresponds to each ink tank, from
left (the opposite side of the home position) to right,
respectively. Error code 1410 is for the leftmost ink
tank (PGI-5BK).
Replace the empty ink tank(s), and close the
scanning unit (printer cover).
Printing with an empty ink tank can damage the
printer.
To continue printing without replacing the ink tank
(s), press the Resume/Cancel button for 5 sec. or
longer to disable the function to detect the
remaining ink amount. After the operation, it is
recorded in the printer that the function to detect the
remaining ink amount was disabled.
1-5
The service call error, indicating the ink
absorber is full, is likely to occur soon.
Data which was to be printed on the back
side of paper at error occurrence is
skipped (not printed).
The error will occur (a) when the print
head alignment pattern is not printed due
to no ink or non-ejection of ink, (b) when
the sensor's AD value is incorrect, or (c)
when the paper is shorter than the
specified length.
The error is indicated when raw ink is
detected but the dot count number
exceeds the threshold of complete
exhaustion of ink.
Ink tank positioning (from left to right):
BK, PigBK, Y, M, C
The error is indicated when "no raw ink"
is detected and when the dot count
number exceeds the threshold of complete
exhaustion of ink.