JVC KD-S51 Service Manual page 8

QQ
3.1.6 Removing the main board 3 7 63 1515 0
(See Fig.7)
• Prior to performing the following procedure, remove the front
panel assembly, front chassis assembly, side panel, bottom
cover and rear bracket.
(1) Remove the two screws H attaching the main board.
(2) Disconnect the connector
board.
3.1.7 Removing the CD mecha control board
(See Fig.8)
• Prior to performing the following procedure, remove the front
panel assembly, front chassis assembly, side panel, bottom
cover, rear bracket and main board.
(1) Disconnect the card wire from the connector
CD mecha control board.
(2) Remove the five screws J attaching the CD mecha control
board.
(3) Release the claw f, and take out the CD mecha control
TE
L 13942296513
board.
Reference:
When attaching the CD mecha control board, attach it to the
claw f and pass the slot g of it into the boss of the CD mecha-
nism assembly.
www
.
1-8 (No.MA124)
http://www.xiaoyu163.com
CN501 and take out the main
CN601 on the
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
CN501
H
J
Claw f
Q Q
3 6 7 1 3 1 5
J
CN601
co
.
9 4 2 8
Main board
H
Fig.7
Slot g
0 5 8 2 9 9 4 2 8
J
CD mecha control board
Fig.8
m
9 9
9 9