Advertisement

CD RECEIVER
RECEPTOR CON CD
RECEPTEUR CD
KD-S6350/KD-S590
For installation and connections, refer to the separate manual.
Para la instalación y las conexiones, refiérase al manual separado.
Pour l'installation et les raccordements, se référer au manuel séparé.
KD-S6350
S
KD-S590
INSTRUCTIONS
MANUAL DE INSTRUCCIONES
MANUEL D'INSTRUCTIONS
DIRECT
TRACK
ACCESS
MO
RPT
RND
MODE
DIRECT TRACK ACCESS
7
8
9
10
11
12
For customer Use:
Enter below the Model No. and
Serial No. which are located on
the top or bottom of the cabinet.
Retain this information for future
reference.
Model No.
Serial No.
FM
CD
SSM
AM
SCM
GET0116-001A
[J]

Advertisement

Table of Contents
loading

Summary of Contents for JVC KD-S590

  • Page 1 CD RECEIVER RECEPTOR CON CD RECEPTEUR CD KD-S6350/KD-S590 For installation and connections, refer to the separate manual. Para la instalación y las conexiones, refiérase al manual separado. Pour l’installation et les raccordements, se référer au manuel séparé. INSTRUCTIONS MANUAL DE INSTRUCCIONES MANUEL D’INSTRUCTIONS...
  • Page 2: How To Reset Your Unit

    INFORMATION (For USA) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
  • Page 3: Table Of Contents

    Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. CONTENTS How to reset your unit ... 2 How to use the MODE button ... 3 LOCATION OF THE BUTTONS ...4...
  • Page 4: Location Of The Buttons

    LOCATION OF THE BUTTONS Control panel Display window 12 34 (Standby/On/Attenuator) button 2 +/– button 3 LOUD (Loudness) button 4 SEL (Select) button 5 Loading slot 6 AM button 7 0 (Eject) button 8 CD button 9 FM button p Remote sensor (only for KD-S6350) q DISP (Display) button w MO (Monaural) button e RPT (Repeat) button...
  • Page 5: Remote Controller (Only For Kd-S6350)

    Remote controller (only for KD-S6350) This section is only for KD-S6350. 1 • Turns on the unit if pressed when the unit is turned off. • Turns off the unit if pressed and held until “SEE YOU” appears on the display. •...
  • Page 6: (Only For Kd-S6350)

    Preparing the remote controller This section is ONLY FOR KD-S6350. Before using the remote controller: • Aim the remote controller directly at the remote sensor on the main unit. Make sure there is no obstacle in between. Remote sensor • Do not expose the remote sensor to strong light (direct sunlight or artificial lighting).
  • Page 7: Basic Operations

    Turning on the power Turn on the power. Note on One-Touch Operation: When you select a source in step 2 below, the power automatically comes on. You do not have to press this button to turn on the power. Select the source. To operate the tuner (FM or AM), see pages 8 –...
  • Page 8: Radio Operations

    RADIO OPERATIONS Listening to the radio You can use either automatic searching or manual searching to tune in to a particular station. Searching a station automatically: Auto search Select the band (FM 1 – 3, AM). Lights up when receiving an FM stereo broadcast with Selected band appears sufficient signal strength...
  • Page 9: Storing Stations In Memory

    Tune in to a station you want while “M” is flashing. Press stations of higher frequencies. Press 4 stations of lower frequencies. • If you release your finger from the button, the manual mode will automatically turn off after 5 seconds.
  • Page 10: Tuning In To A Preset Station

    Manual preset You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually. Ex: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band. Select the band (FM1 – 3, AM) you want to store FM stations into (in this example, FM1).
  • Page 11: Cd Operations

    Playing a CD Insert a disc into the loading slot. The unit turns on, draws a CD and starts playback automatically. Note: When a CD is inserted upside down, the CD automatically ejects. The CD-in indicator flashes The CD-in indicator lights up Total playing time of Total track number of the inserted disc...
  • Page 12: Locating A Track Or A Particular Portion On A Cd

    Locating a track or a particular portion on a CD To fast-forward or reverse the track Press and hold while playing a CD, to fast forward the track. Press and hold 4 while playing a CD, to reverse the track. To go to the next tracks or the previous tracks Press...
  • Page 13: Prohibiting Cd Ejection

    Prohibiting CD ejection You can prohibit the CD ejection and can lock a CD in the loading slot. Press and hold CD and 0 for more than 2 seconds. “EJECT” flashes on the display for about 5 seconds, and the CD is locked and cannot be ejected.
  • Page 14: Sound Adjustments

    SOUND ADJUSTMENTS Adjusting the sound You can adjust the sound characteristics to your preference. Select the item you want to adjust. Each time you press the button, the adjustable items change as follows: Indication To do: Adjust the bass. (Bass) Adjust the treble.
  • Page 15: Using The Sound Control Memory (Scm)

    Using the Sound Control Memory (SCM) You can select and store a preset sound adjustment suitable to each playback source. (Advanced SCM) Selecting and storing the sound modes Once you select a sound mode, it is stored in memory. It will be recalled every time you select the same source and will be shown on the display.
  • Page 16: Storing Your Own Sound Adjustments

    Storing your own sound adjustment You can adjust the sound modes (BEAT, SOFT, POP: see page 15) to your preference and store your own adjustments in memory. • There is a time limit in doing the following procedure. If the setting is cancelled before you finish, start from step 1 again.
  • Page 17: Other Main Functions

    Setting the clock Press and hold SEL (Select) for more than 2 seconds. “CLOCK H”, “CLOCK M”, “SCM LINK” or “LEVEL” appears on the display. Set the hour. 1 Select “CLOCK H” if not shown on the display. 2 Adjust the hour. Set the minute.
  • Page 18: Selecting The Level Display

    Selecting the level display You can select the level display according to your preference. When shipped from the factory, “VOL 2” is selected. VOL 1 : Shows the volume level indicator. VOL 2 : Alternates “VOL 1” setting and illumination display. : Erase the volume level indicator.
  • Page 19: Detaching The Control Panel

    Detaching the control panel You can detach the control panel when leaving the car. When detaching or attaching the control panel, be careful not to damage the connectors on the back of the control panel and on the panel holder. How to detach the control panel Before detaching the control panel, be sure to turn off the power.
  • Page 20: Maintenance

    MAINTENANCE Handling CDs This unit has been designed to reproduce CDs and CD-Rs. • Other discs cannot be played back. This unit is not compatible with MP3. How to handle CDs When removing a CD from its case, press down the center holder of the case and lift the CD out, holding it by the edges.
  • Page 21: Troubleshooting

    What appears to be trouble is not always serious. Check the following points before calling a service center. Symptoms • CD cannot be played back. • CD sound is sometimes interrupted. • “NO DISC” appears on the display. • Sound cannot be heard from the speakers.
  • Page 22: Specifications

    SPECIFICATIONS AUDIO AMPLIFIER SECTION Maximum Power Output: Front: 45 watts per channel Rear: 45 watts per channel Continuous Power Output (RMS): Front: 17 watts per channel into 4 Ω, 40 Hz to 20 000 Hz at no more than 0.8% total harmonic distortion. 17 watts per channel into 4 Ω, Rear: 40 Hz to 20 000 Hz at no more than...
  • Page 23 Having TROUBLE with operation? Please reset your unit Refer to page of How to Reset Still having trouble?? USA ONLY Call 1-800-252-5722 http://www.jvc.com We can help you! VICTOR COMPANY OF JAPAN, LIMITED 1002KKSFLEJEIN EN, SP, FR © 2002 VICTOR COMPANY OF JAPAN, LIMITED...
  • Page 24: Localizacion De Averias

    • The following illustration shows a typical installation. However, you should make adjustments corresponding to your specific car. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits. Before mounting: Press (Control Panel Release button) to detach the control panel if already attached.
  • Page 25 • When using the optional stay • Cuando emplea un soporte opcional • Lors de l'utilisation du hauban en option Washer Arandela Rondelle Fire wall Tabique a prueba de incendios Cloison Dashboard Tablero de instrumentos Tableau de bord Sleeve Cubierta Manchon Removing the unit •...
  • Page 26: Electrical Connections

    NEGATIVA solamente. Si su vehículo no posee este sistema, será necesario un inversor de tensión, que puede ser adquirido en los concesionarios de JVC de equipos de audio para automóviles. • Reemplace el fusible por uno con la corriente especificada. Si el fusible se quemase frecuentemente consulte con su concesionario de JVC de equipos de audio para automóviles.
  • Page 27 Connections Adding Other Equipment / Conexiones para añadir otros equipos / Raccordement pour ajouter d’autres appareils Amplifier / Amplificador / Amplificateur You can connect an amplifier to upgrade your car stereo system. • Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.

This manual is also suitable for:

Kd-s5mKd-s5mjKd-s6250Kd-s6250jKd-s6350Model kd-s580j

Table of Contents