Toshiba Satellite L20 Series Maintenance Manual page 68

2.5 2.5-inch HDD
Procedure 4 Test Program Check
Run the HDD test program stored on the maintenance test program disk for all test items.
See Chapter 3 for details on how to use the test program.
If an error is detected during the HDD test, an error code and status will be displayed. The
error codes and their status names are listed in Table 2-1. If an error code is not generated
and the problem still exists, go to Procedure 5.
Code
1 Get Parameter Fail !
2 Read Old Data
Error
3 Write Pattern
Error
4 Read Back Data
Error
5 Data Compare Error
6 Restore Data
Error
7 Read Verify Error
9 Seek Error
10 Disk Controller Self Test Failed
11 Disk Controller Test unexpected interrupt Failed
12 Disk Controller action Test Failed
13 Disk dos not support
SMART
14 Disk read attribute threshold
error
15 Disk read attribute value error
16 Disk SMART attribute value error
EQUIUM M40/M45/Satellite M40/M45 Maintenance Manual
Table 2- 1 HDD error code and status
Status
2 Troubleshooting
2-13