Unit Beeps; Memory Dialling - Sagem D16T User Manual

D16T/D18T/D21T
13.2.2. Telephone
No dial tone
Dial tone is OK, but can't dial out
Handset does not ring
You experience static, noise or fading in
and out

13.2.3. Unit beeps

- Place handset in base for 20 seconds to reset the security code. If that doesn't work,
charge battery for 15 hours.
- Clean charging contacts on handset and base with a soft cloth.
- See solutions for «No dial tone».
- Replace battery.

13.2.4. Memory dialling

- Did you program the memory location keys correctly?
- Did you follow proper dialling sequence?
- Make sure the tone/pulse setting is correct.
- Did you reprogram numbers into memory after power outage or battery replacement.
Problem
Check installation:
- Is the base power cord connected to a working
outlet?
- Is the telephone line cord connected to the
base unit and the wall jack?
Disconnect the base from the wall jack and
connect another phone to the same jack. If
there is no dial tone in the second phone,
the problem might be your wiring or local
service.
Is the handset out of range of the base?
Make sure the battery is properly charged
(12 hours).
Is the battery pack installed correctly?
Did the IN USE indicator come on?
The battery may need to be charged.
Make sure the tone/pulse setting is correct.
Make sure the RINGER setting on the
handset is programmed to ON.
You may have too many extension phones
on your line. Try unplugging some phones.
See solutions for «NO dial tone».
Change channels.
Is handset out of range?
Move closer to the base.
Does the base need to be relocated?
Charge battery.
Make sure base is not plugged into an
outlet with another household appliance.
- 19 -
Solution