Table of Contents
Advertisement
Safety precautions
A
WARNING
To prevent injury or fire, take the following precautions:
• Insert the unit all the way in until it is fully locked in place. Otherwise, it may fall out of place when jolted.
• To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside the unit.
• If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your Kenwood dealer.
• Do not connect the unit to the front monitor. This unit is for rear seat entertainment.
• Do not attempt to pull down or hang from the unit after proper installation.
Doing so may cause damage to the unit or cause personal injury.
A
CAUTION
To prevent damage to the unit, take the following precautions:
• Make sure to ground the unit to a negative 12V DC power supply.
• Do not open the top or bottom covers of the unit.
• Do not install the unit in a spot exposed to direct sunlight or excessive heat or humidity. Also avoid places with too much
dust or the possibility of water splashing.
• Do not use your own screws. Use only the screws provided. If you use the worng screws, you could damage the unit.
When replacing a fuse, only use a new one with the prescribed rating. Using a fuse with the wrong
rating may cause your unit to malfunction.
NOTE
• If you experience problems during installation, consult your Kenwood dealer.
• The illustrations of the display and the panel appearing in this manual are examples used to explain more clearly how
the controls are used.
Therefore, what appears on the display in the illustrations may differ from what appears on the actual display
some of the illustrations on the display may represent something impossible in actual operation.
Lens Fogging
Right after you turn on the car heater in cold weather, dew or condensation may form on the lens in the
DVD player of the unit. Called lens fogging, DVD may not be played in such condensation.
If the unit still does not operate normally after while, consult your Kenwood dealer.
Cleaning the Unit
If the faceplate of this unit is stained, wipe it with a dry soft cloth such as a silicon cloth.
If the faceplate is stained badly, wipe the stain off with a cloth moistened with neutral cleaner, then wipe neutral cleaner off.
Lt
• Applying spray cleaner directly to the unit may affect its mechanical parts. Wiping the faceplate with a hard cloth or using
a volatile liquid such as thinner or alcohol may scratch the surface or erase characters.
This product incorporates copyright protection technology that is protected by U.S.patents and other intellectual property
rights. Use of this copyright protection technology must be authorized by Macrovision. Reverse engineering or disassembly is
prohibited.
NOTE
This Class B digital apparatus complies with Canadian ICES-003.
_4
English
Advertisement
Table of Contents
