Table of Contents
Advertisement
Insta IlationCProfessional installation recommended)
1. Unpack and check the contents.
~
This shape is designed
,
for the wire outlet
i
X4: Bracket Screw(Short)
I
X4: Bracket Screw(Long)
1
X4: Unit Screw
Unit
Trim Ring
Bracket
Installation Screw
2. Remove the protection screw
before you install the unit.
Protection screw for Pickup.
You must remove it
before you install.
Protection sheet for Digital Output.
Please remove it when you install.
Direction of rear seat
1
-~~
.
~:
1
:
Dire'ction of
front seat
6
'
*
Notice
. . .
Use only the
• .
supplied
screws in
this shape.
Please locate
this part of the
1
bracket in this
direction
Direction of rear seat
3. Attach the metal support bracket to the
ceiling support beam(s) of your vehicle
by using the supplied screws.
There are long and short screws for
the bracket. A user can use either of
them dependant upon the situation.
Take extra care not to penetrate the
roof of your vehicle.
FM transmitter antenna
(FM TX)
------~--~
Direction of
front seat
4. Before installing the unit to the ceiling,
it is recommended to setup FM TX antenna
as shown on the left side picture.
FM TX antenna is helpful for increasing the
FM TX signal and lowering noise in audio.
Please stretch the antenna cable toward the
. vehicle radio antenna.
English
27a
Advertisement
Table of Contents
