Pride Sundancer User Manual page 37

X I I . C A R E
FUSE REPLACEMENT
In the event the 5-amp fuse should cease to work:
n Remove the fuse by pulling it out of its slot.
n Examine the fuse to be sure it is blown. See figures 20 and 21.
n Insert a new fuse of the proper rating.
FIGURE 20. WORKING FUSE
CAUTION! Do not use regular automotive-type 12-volt light bulbs; your scooter is equipped with a
24-volt electrical system.
REAR LIGHTS
Light bulbs for the rear running lights and turn signals are easily replaceable.
NOTE: Replacement light bulbs can be purchased from your authorized Pride provider.
n Remove the light cover.
n Gently remove the bulb.
n Insert a new 24V, 5 watt bulb.
n Replace the light cover.
STORING YOUR SCOOTER
If you plan on not using your scooter for an extended period of time, it is best to:
n Fully charge its batteries prior to storage.
n Disconnect both battery harnesses.
n Store your scooter in a warm, dry environment.
n Avoid storing your scooter where it will be exposed to temperature extremes.
WARNING! If your scooter’s batteries do become frozen, do not attempt to charge them. Cold or
frozen batteries should be allowed to warm up for several days prior to recharging.
For prolonged storage, you may wish to place several boards under the frame of your scooter to raise it off of the
ground. This takes the weight off the tires and reduces the possibility of flat spots developing on the areas of the
tires contacting the ground.
Sundancer
A N D M A I N T E N A N C E
FIGURE 21. BLOWN FUSE (REPLACE)
37