Table of Contents
Advertisement
Option Programming – fit the tuner to the B&O set up
Option programming is only required for the initial installation of the tuner. The programming itself is
carried out with a Bang & Olufsen remote, pointing directly towards the tuner. The tuner does not need
to be connected to a Bang & Olufsen device, in order to be Option programmed.
The objective is to fit the tuner's performance to the actual audio set up.
y
Some installations require the tuner to be operated as an
source, whereas in some other
B
installations only the
source might be available.
The option programming procedure is always initiated by pressing the programming switch on the
tuner's back shortly to make it ready for programming.
L
The programming sequence itself using the Bang & Olufsen remote, starts off with pressing the
w
key followed by 3 digits and finished by pressing the
key.
All allowed options have a 3 digit configuration.
If the programming procedure is not successful the first time, repeating it is recommended.
Option 106 is programmed as follows:
L*1 106w
L
h
*1 Using a Beolink 1000, MK I or II
has to be replaced by
.
LINK
Allowed options are listed in the tables found in Source & Option Selection below.
6
www.oneremote.dk
Advertisement
Table of Contents
