Changing The Road Types Used In Route Planning - Jensen VX7020 Operating Instructions Manual

Changing the Road Types Used in Route Planning

To recalculate the active route with different road type preferences, do as follows.
These changes can also be made in Settings.
1. On the Map screen, tap
2. Tap any of the listed road types to modify the route. If needed, scroll the list
for all road types. You have the following options (their order depends on the
selected vehicle type):
•
car or you are towing another vehicle.
•
vignette to use the road for a longer period of time. They can be enabled or
disabled separately from toll roads.
•
use charge) in the routes by default. If you disable toll roads, iGO primo plans
the best toll-free route.
•
However, a map does not necessarily contain information about the
accessibility of temporary ferries. You might also need to pay a fare on ferries.
•
can be in a bad condition and usually you cannot reach the speed limit on
them.
•
passengers are traveling in the vehicle. You should check whether you are
allowed to use carpool lanes before enabling this road type.
3. Tap
The orange line now shows the new recommended route.
102
128-9291 Jensen VX7020 Navigation Manual.indd 102
and then tap
- You might need to avoid freeways when you are driving a slow
- Charge roads are pay roads where you can purchase a pass or
- iGO primo includes toll roads (pay roads where there is a per-
- iGO primo includes ferries in a planned route by default.
- iGO primo excludes unpaved roads by default: unpaved roads
- Carpool or HOV lanes can be used if a given number of
to confirm the changes. iGO primo recalculates the route.
VX7020
.
3/17/2014 1:26:54 PM