Chevrolet Corvette 2015 Owner's Manual page 260

1. Open the hood. See Hood on
page 10-6.
2. Remove the four bolts (1) and
the hood extractor duct (2).
3. Reverse Step 2 to replace the
hood extractor duct.
To inspect or replace the engine air
cleaner/filter:
1. Surge Tank Coolant Hose
2. Screws (2)
3. Hose Retainers (2)
4. Air Duct Clamp
5. Electrical Connector
Caution
If the engine coolant surge tank
hose is not carefully lifted out of
the hose retainers on the air
cleaner/filter cover assembly, it
may be damaged and cause
engine coolant to leak. Damage
would not be covered by the
vehicle warranty.
1. Carefully lift the surge tank
coolant hose (1) from both hose
retainers (3) and position the
hose to be able to remove the
screws securing the air cleaner/
filter endcap.
2. Loosen the air duct clamp (4) at
the air cleaner/filter housing
endcap and move the duct out of
the way.
3. Remove the electrical
connector (5) from the sensor.
4. Remove the two screws (2).
Vehicle Care
5. Turn the air cleaner/filter endcap
downward and disengage the
lower endcap mounting tabs
from the lower retention hinge
features. Be sure to insert the
lower endcap mounting tabs fully
into the housing retention hinge
features before turning the
endcap upward and replacing
the screws.
6. Inspect or replace the air
cleaner/filter.
7. Reverse Steps 1 6 to replace
the air cleaner/filter endcap.
10-21