General Information - Bunn My Café MCA Use And Care Manual

Improper installation could result in permanent damage and void the
limited warranty. Read & follow instructions on pages 10-11.
• Use CAUTION when dispensing hot water from the brewer. The water
®
from your BUNN Pod brewer is approximately 200°F (93°C). This is
approximately 50°F (10°C) hotter than the hot water from your faucet and
must be handled with care.
• This brewer is designed to remain plugged in at all times (except during initial
installation, cleaning, or when brewer will not be used for an extended period of
time).
• A power switch is provided on the lower left side to completely shut off all
electrical components when your plans take you away from the brewer for three
or more days. Safety features, designed into the BUNN
daily use of this switch unnecessary.
• Whenever the brewer has been shut off or unplugged for an extended period of
time, rinse the reservoir and refi ll with fresh cold water before using. It is also
recommended that the brewer be cycled. (See page 15)
®
• Your BUNN Pod brewer has a specially designed tank to keep the water inside
at the proper temperature. This constant supply of hot water assures the correct
method of brewing in less than one minute.
• When inserting a pod into the pod holder, it is important to seat the pod all the
way into the holder cavity. Leaks could occur if the pod is too large, or does not
seat completely into the holder cavity. Ensure that all of the paper edge and any
tabs of the pod are inserted into the holder cavity.
• Prior to brewing, make certain pod holder is securely locked into the brewer.
Failure to do so can result in a burn hazard.
• While brewing, the incoming water in the tank is also being heated to the proper
temperature and held until needed.
• The brewer is equipped with a 120 volt, 3-prong grounded cord set. The plug is
provided with a round grounding pin. (International brewers are equipped with
a 230 volt, grounded cord set. The plug is provided with a grounding circuit
in compliance with local requirements) This is a safety feature and allows the
plug to fi t into a properly grounded outlet. If the plug does not fi t into the outlet,
contact an electrician to update your outlet. Attempting to bypass the safety
aspect of this plug will void the warranty.
• The sprayhead may become loose over time. Unplug the machine and allow it
to cool down before tightening or removing the sprayhead. Use extreme caution
not to burn yourself. Tighten or remove the sprayhead with your fi ngertips.

GENERAL INFORMATION

CONTINUED
6
®
Pod brewer, make the