Using the oscillator
1.
In the talkback/oscillator section, press [DISP] to access
the TALKBACK/OSCILLATOR screen.
2.
Press [F2 (OSC)] to access the OSC tab.
fig.ScrOsc.eps
3.
Use the oscillator type select buttons to select the type of
signal you want to generate.
4.
Use the oscillator output destination select buttons to
select the bus to which the oscillator will be sent.
5.
When you press [F3 (OSC ON)] to turn it on, the oscillator
signal will be sent to the bus you selected in step 4.
Talkback/Oscillator
153