Akai Professional DPS24 Service Manual page 13

CD-R/CD-RW Drive
1. From the bottom of the unit, remove the screws for the bottom cover and open the bottom.
2. Remove the cover for the CD-R/RW Drive on the Front Panel.
3. Jumper settingof the CD-R/RW has to be in SLAVE mode with short pin on the CD-R/RW.
4. Referring to the illustration, slide the CD-R/RW Drive from the front and mount it on the bottom chassis with
the screws inside the Internal Disk Mounting Kit. There are inch-threaded screws and millimeter-threaded
screws inside. Be sure to use the appropriate type.
5. Connect the 4-pin Power Cable and 40-pin Disk Drive Cable as illustrated.
On the Disk Drive Cable, BLUE connector has to be connect to the CPU board on DPS24.
6. Place the bottom cover back and tighten all screws.
SERVICE MANUAL
13