Akai Professional DPS24 Service Manual page 12

Hard Disk Drive
1. From the bottom of the unit, remove the screws for the bottom cover and open the bottom.
2. Jumper setting of the hard disk has to be in MASTER mode with the short pin on the hard disk.
3. Referring to the illustration, slide the Hard Disk Drive in the disk holder and mount it with the screws inside
the Internal Disk Mounting Kit. There are inch-threaded screws and millimeter-threaded screws inside. Be
sure to use the appropriate type.
4. Connect the 4-pin Power Cable and 40-pin Disk Drive Cable as illustrated.
On the Disk Drive Cable, BLUE connector has to be connected to the CPU board on DPS24.
ZS-418538J
PAN N06-32UNCXSMM
STL CMT
5. Place the bottom cover back and tighten all screws.
12
SERVICE MANUAL