Live Mode; Channel Mode - Laney Prism P20 Operating Instructions Manual

Hero Mode
Here you will find eleven pre-set sounds we have chosen. These can not be
overwritten but can be temporarily edited and then stored into the
channels if required. (See Hero preset list.Page 23)

Live Mode

In this mode all the controls operate exactly as indicated on the fascia
panel.
When you find the sound you like it can be stored to a channel as required.

Channel Mode

Each channel button is factory programmed with a "Cool Sound". These
settings can be kept as is, or edited to suit your own sound, or replaced
entirely with a new sound of your own design.(Keep a note of your settings,
because if a "Factory Reset" is used any edits carried out here will be reset
to factory settings).
When you have created a sound in the LIVE mode or any sound the amplifier is producing at the time, you can store
it to a Channel simply by pressing and holding down the desired Channel button for two seconds. (The store and
Channel button light will flash to indicate the store has taken place)
If you decide the sound is still not quite right you can re-edit it in the Channel and then press and hold the Channel
button again to overwrite.
Effects
There are eleven carefully chosen built in studio quality combinations of effects available.
These can be used as factory set or can be extensively edited as desired, temporarily, or stored for future use.
All settings are retained after power down so none of your new sounds are ever lost.