Section 3: Finishing - Montigo R620-ST Indoor Installation & Maintenance Manual

Section 3: Finishing

20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
12 11 10 9 8 7 6 5 4 3 2 1
Glass
Figure 1 Sec.3 Combustible mantles and facings. (Not to scale)
Fireplace Facing
When selecting the finish material for your fireplace, it is important
to remember the following:
If the surround of the fireplace is to be painted to match the room decor,
heat-resistant paint must be provided . Also, decorative facing must
not extend past the fireplace opening at all, because it will interfere
with the access to retainers for removal of glass door and access to
the lower compartment.
Mantels & Surrounds
NOTE: National Canadian Gas Association mantel test requirements
are for fire hazard prevention to combustible materials.
Please be aware; temperatures over the mantel will rise above normal
room temperature and walls above fireplace may be hot to touch.
Warning:
We recommend careful consideration be given to the effects of
elevated mantel temperatures which may be in excess of product
design, for example: candles, plastic or pictures. This can cause
melting, deformation, discoloration or premature failure of T.V. and
radio components.
XG0773 - 150127
Installation
Combustible
facing material
Start of combustible
framing
Combustible
construction allowed
in shaded area
Note: Images are shown without screens for clarity purposes.
However, your fireplace should not be operated without proper
Top of
fireplace
installation of screens.
Non-combustible
headers supplied by
Montigo (may be
placed where required
for fastening facing)
R520-ST & R620-ST Power Vent Indoor Gas Fireplace
Page 11