Advertisement
Alignment and Adjustment
2-9. PB Output Level (Hi8)
a. Preparations
HI8 STANDARD COLOR BAR TAPE
TAPE
RECORDED WITH SP SPEED
EQUIPMENT
DC POWER SUPPLY, OSCILLOSCOPE
OTHER
You need a monitor terminated with 75Ω.
TEST POINT
CN605 PIN13
ADDRESS
14
NAME
PB OUT-LEVEL (HI8)
b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the ÒTITLE (MODE UP)/DATE/TIME
(MODE DOWN)Ó button of CAMCORDER so
as to select the address 14.
e. Insert a Hi-8 standard color bar tape and press
the PLAY button.
f. Connect the oscilloscope to the addressed Test
Point.
14
13
12
11
10
9
8
7
6
5
4
3
2
1
g. Press the ÒEDIT + (DATA UP)/EDIT Ð (DATA
DOWN)Ó button so that the CN605 PIN13 is
1.0±0.02Vp-p from SYNC to peak level.
APPROX.
0.7V
APPROX.
0.3V
H
h. Be sure to press the ÒMENU/ENTER(CONFIRM)Ó
button of CAMCORDER to memorize setting.
i. Reset the power source so as to fix the new data
to the camcorderÕs EEPROM.
5-38
14
AUDIO OUT R
13
VIDEO OUT
12
AUDIO OUT R
11
PB RF
10
AUDIO OUT L
9
HD SW
8
VCR UNREG
7
JIG CS
6
VCR UNREG
5
JIG SCK
4
SS GND
3
JIG SO
2
JIG DETECT
1
JIG SI
WHITE ( APPROX. 100% )
1.0 0.02Vp-p
2-10. Y-FM Carrier (Hi8)
: This adjustment is performed to set the sync-
tip level of the composite video signal.
Maladjusted Y-FM carrier impact to the play-
back picture, there may be black or white dot
noise.
a. Preparations
TAPE
HI8 TAPE FOR RECORDING
EQUIPMENT
DC POWER SUPPLY, FREQUENCY COUNTER
OTHER
TEST POINT
IC 201 PIN 41
ADDRESS
15
NAME
Y-FM CARRIER (HI-8)
b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the ÒTITLE (MODE UP)/DATE/TIME
(MODE DOWN)Ó button of CAMCORDER so
as to select the address 15.
e. Insert a Hi-8 Tape to the camcorder.
f. Press the START/STOP button on the Rear
board so as to set the camcorder to RECORD-
ING mode.
g. Connect the frequency counter to the addressed
Test Point.
h. Press the ÒEDIT + (DATA UP)/EDIT Ð (DATA
DOWN)Ó button so as to set the frequency to
5.99MHz ±0.02MHz
i. Be sure to press the ÒMENU/ENTER(CON-
FIRM)Ó button of CAMCORDER to memorize
setting.
j. Reset the power source so as to fix the new data
to the camcorderÕs EEPROM.
Samsung Electronics
Advertisement
