Connecting Information; Connecting The Cords; Using The Tap - Sony XAV-A1 Installation/Connections Manual

Connecting Information

For details, see the section "1 Car Systems Connections" (next page).
Notes
• Be sure to connect the power input
cord after all other cords are connected.
• If the parking brake switch cord is too
thin, connect the parking cord to the
parking brake switch cord directly
without using the tap.
6

Connecting the cords

Connect each cord using the taps. For the combination of each
cord, see the following table. Also, see the section "1 Car
Systems Connections" (next page).
Main unit side Car side
Purple/white Power terminal cord of the back lamp
Light green Parking brake switch cord

Using the tap

Tap 7
Connecting the parking cord
The mounting position of the parking brake switch cord depends
on your car. Refer to the system connection illustrations below
and consult your car dealer or your nearest Sony dealer for
further details.
Foot brake type
Parking brake
switch cord
The cord for utilizing the back camera better
Purple/white cord (for the connection to the power terminal
cord of the back lamp)
If you connect the purple/white cord to the power terminal cord
of the back lamp, the image of back camera will be automatically
displayed on the monitor when a back lamp lights up. You can
adjust the parking location viewing the image of back camera
when you backup.
Parking brake switch cord
Parking cord
(Light green)
Hand brake type
Parking brake
switch cord