Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
ProCurve# show sflow 2 sampling-polling A1-A4
Port
| Sampling
| Enabled
----- + -------- -------- ------
A1
Yes(2)
A2
---
A3
No(1)
A4
Yes(3)
Figure 13-13. Example of Viewing sFlow Sampling and Polling Information
N o t e
13-28
Note the following details:
Destination Address remains blank unless it has been configured.
■
■
Datagrams Sent shows the number of datagrams sent by the switch
agent to the management station since the switch agent was last
enabled.
■
Timeout displays the number of seconds remaining before the switch
agent will automatically disable sFlow (this is set by the management
station and decrements with time).
■
Max Datagram Size shows the currently set value (typically a
default value, but this can also be set by the management station).
The show sflow <instance> sampling-polling [port-list] command displays infor
mation about sFlow sampling and polling on the switch. You can specify a list
or range of ports for which to view sampling information.
Number denotes the sampling/polling instance to which the receiver is coupled.
Rate
Header
40
128
---
---
0
100
50
128
The sampling and polling instances (noted in parentheses) coupled to a
specific receiver instance are assigned dynamically, and so the instance
numbers may not always match. The key thing to note is whether sampling or
polling is enabled on a port, and the sampling rates or polling intervals for the
receiver instance configured on each port.
Dropped
|
Polling
Samples
|
----------
+
1234567890
0
Yes(1)
898703
0
Enabled
Interval
-------
--------
---
---
60
No
30
No(3)
0