Table of Contents
Advertisement
Motion Detection Menu (cont)
Motion Area: Select the area of the Camera to detect motion. Motion
occurring outside this designated area will not trigger a recording.
This feature is helpful in high traffic areas where only a small portion of the
screen needs to be monitored for example, looking down a driveway with a busy
road next to it.
Important: To enable Motion Recording you must set the Sensitivity, Motion
Area for each camera AND set Motion Record in the Record Schedule menu.
Screen Menu
Border: Applies a border between the cameras in multi camera view.
Video Adjustment: Adjust the display to fit on your TV monitor.
Auto Switching: When active, in live view mode, the DVR will automatically
switch between camera channels in full screen mode. Set the delay from 1-10
seconds between changes or Off. To activate Auto Switching, press the FAST
FORWARD
/- button when viewing your cameras. Press the
again to stop Auto Switching.
Use the UP, DOWN, REWIND & FAST
FOWARD buttons to move the cursor.
Press the SET button to begin to
draw the motion detection area.
Using the arrow buttons draw your
desired motion area and press the
SET button again once complete.
In the example to the left, the blue
motion box is drawn over the door.
Only motion occurring in this area will
trigger recording i.e. the door opening.
The Screen menu adjusts the display of
cameras in the main camera view.
/- button
13
Advertisement
Chapters
Table of Contents
