Lennox LSS-35CN Installation Instructions Manual page 24

Remote Control System
The Remote and Receiver allows you to com-
mand the functions of your fireplace from
the comfort of you chair and is configured to
control the On/Off primary burner operation, its
flame levels (through six levels) and provides
On/Off and Smart thermostatic control of the
Symmetry appliance
The system controls fan speed through six (6)
levels and has a constantly powered 110V/60Hz
power outlet.
The Receiver connects directly to the gas valve,
stepper motor and the Fan Control Module
with and umbilical cord wiring harness. The
Receiver is powered by 4 AA type batteries,
located within.
The Receiver accepts commands via radio
frequency from the Transmitter and does not
require line-of-sight operation.
The Receiver three position slider switch can
be set to one of three positions: ON (Manual
Override), REMOTE (Remote Control) or OFF.
Initializing The System For The First Time
Install the 4 AA batteries into the receiver battery
bay (behind the wall switch plate).
Note: The polarity of the battery and insert
into the battery bay as indicated on the Battery
cover (+/-).
Place the 3 position slider switch in the "Remote"
position (see Figure 42 ). Using the end of a
paper clip, or other similar object, insert the
end of the paper clip into the hole marked "PRG"
on the Receiver front cover. The Receiver will
"beep" three (3) times to indicate that it is ready
to synchronize with a Transmitter.
24
Slider Switch In
Remote Position
On
Remote
Off
PRG
Figure 42
Transmission
Thermostat
Off/On/Smart
Set Point
Temp./Level/State
Flame On
Figure 43
Flame Level 5
Figure 44
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Install the 3 AAA type batteries in the Trans-
mitter battery bay, located on the base of the
Transmitter. With the batteries already installed
in the Transmitter, push the ON button. The
Receiver will "beep" four times to indicate the
Transmitter's command is accepted and sets
to the particular code of that Transmitter. The
system is now initialized.
Low Battery Power Detection
The life span of the Receiver batteries depends
on various factors: quality of the batteries used,
the number of ignitions of the appliance, the
number of changes to the room thermostat
set point, etc.
Child Safety Lock-Out
Low Battery Alarm
Room Temperature
Fan Control
Maximum Level Indicatiors
Indicator Icons
Flame Level Maximum
Figure 45