Advertisement
IMPORTANT SAFETY INSTRUCTIONS FOR BATTERIES
WARNING: Batteries can explode, or leak, and can cause injury or
fire. To reduce this risk:
• C arefully follow all instructions and warnings on the battery label
and package.
• A lways insert batteries correctly with regard to polarity (+ and –),
marked on the battery and the equipment.
• Do not short battery terminals.
• Do not charge batteries.
• D o not mix old and new batteries. Replace all of them at the same
time with new batteries of the same brand and type.
• R emove dead batteries immediately and dispose of per local
codes.
• Do not dispose of batteries in fire.
• K eep batteries out of reach of children.
• R emove batteries if the device will not be used for several months.
• Young children and the infirm. This appliance is not intended for
use by young children or infirm persons without supervision.
– This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
– Children should be supervised to ensure that they do not play
with the appliance.
Batteries (Fig. 2)
BATTERY TYPE
This laser operates on three LR6 (AA-size) batteries.
INTENDED USE
The crossline laser DW088-XE has been designed to project laser lines
to aid in professional applications. The tool can be used indoor for
horizontal (level), vertical (plumb). The applications range from layout
of walls and windows to installation of framing track.
DO NOT use under wet conditions or in presence of flammable liquids
or gases.
The crossline laser is a professional tool. DO NOT let children come
into contact with the tool. Supervision is required when inexperienced
SAVE ALL WARNINGS AND
operators use this tool.
INSTRUCTIONS FOR FUTURE REFERENCE
COMPONENTS (Fig. 1)
WARNING: Never modify the power tool or any part of it. Damage or
personal injury could result.
A. On/off switch (vertical laser beam) G. Horizontal laser beam
indicator
B. On/off switch (horizontal laser beam) H.
Pivot bracket
C. Low battery indicator
I. Wall mount
D. Vertical laser beam
J. Battery compartment cover
E. Horizontal laser beam
K. 1/4" x 20 female thread
F. Vertical laser beam indicator
3
FIG. 1
H
K
D
E
I
G
J
A
B
F
C
ASSEMBLY AND ADJUSTMENT
WARNING: Do not place the laser in a position which may cause
anyone to intentionally or unintentionally stare into the laser beam.
Serious eye injury may result from staring at the beam.
Replacing Batteries (Fig. 2)
The DW088-XE
laser operates on
FIG. 2
three LR6 (AA-size)
J
batteries.
1. Open the battery
L
compartment
cover (J).
2. Replace the
batteries (L).
Make sure the
new batteries
are placed as
indicated.
3. Close the
battery
compartment
cover.
WARNING: When replacing batteries, always replace the complete
set. Do not mix old batteries with new ones. Preferably use alkaline
batteries.
LOW BATTERY INDICATOR (FIG. 1)
The tool has been equipped with a low battery indicator (C) located
on the control panel. The low battery indicator is lit while the tool
is switched on. It will blink to indicate that the batteries need to be
replaced and the tool will automatically shut down.
Switch off the tool and remove the batteries as soon as the indicator
blinks.
Setting up the Tool (Fig. 3A–3D)
The tool facilitates various set-ups, making it useful for several
applications.
FLOOR SET-UP
Place the tool on a relatively smooth and level surface.
4
Advertisement
