Troubleshooting - Breville BCG600 Instruction Book

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE
Grinder does • Grinder not plugged in.
not start after
pressing
• Bean hopper not attached
START|CANCEL
correctly.
button
• Grinder has overheated.
• GRIND TIME dial is on
0 seconds.
Motor starts but • No coffee beans in bean
hopper.
no ground coffee
coming from
• Grinder/bean hopper
grind outlet
is blocked.
Can't adjust the • Grind Size Collar too tight.
Grind Size Collar
• Coffee beans and grinds
caught in the burrs.
• Hopper not installed
correctly.
Unable to lock • Coffee beans obstructing
bean hopper into bean hopper locking
device.
position
Not enough/ • Grind amount requires
adjustment.
too much coffee
grind
Portafilter
overfills
Emergency stop?
18
WHAT TO DO
• Plug power cord into
power outlet.
• Lock bean hopper into position.
Refer to the Bean Hopper section
on page 10.
• Leave for 20 minutes to cool down
before using again.
• Rotate the GRIND TIME dial to
increase grind time.
• Fill bean hopper with fresh
coffee beans.
• Remove bean hopper. Inspect
bean hopper and burrs for
blockage. Refer to the Cleaning
Conical Burrs section on page 16.
• Rotate the Bean Hopper to turn the
Grind Size Collar to adjust grind
settings.
• Run the grinder by pressing the
START|CANCEL button while
turning the Hopper.
• Unlock the hopper and install as
per instruction. Refer to the Bean
Hopper section on page 10.
• Remove bean hopper. Clear coffee
beans from top of burrs. Re-lock
the hopper into position & try
again.
• Use GRIND TIME dial to fine
tune the amount more or less.
• It is normal for the correct amount
of coffee to appear overfilled in
your portafilter. Untamped coffee
has approximately three times
the volume of tamped coffee.
• Press the START|CANCEL button
to pause operation.
• Unplug power cord from
power outlet.
19