Mfspoe-8 Installed In The Area With The Network Distribution - Universal Remote MFSPOE-8 Installation Manual

MFSPOE-8 N
MFSPOE-8 Installed in the area with the Network
Distribution
Occasionally you get a retrofit installation where only one CAT5
wire has been run to a room, and there's no way to run another
one. In this case, locate the MFSPOE-8 in the Utility Room, Garage,
or wherever the central distribution point for the Network is located
and install standard network switches in rooms where you plan to
locate a DMS-1200, DMS-100 or SNP-1.
Internet
Contral Distribution Point
for Network Wiring
Cable Modem
Wi-Fi Router
(Network for the rest of the House)
wireless
Access
Point
Notes:
n
The Wireless Access Point CANNOT be connected to the
MFSPOE-8; it must be connected to the Router in the LAN.
n
Standard network switches are used to connect the DMS-
1200, DMS-100 and SNP-1 to the MFSPOE-8. This configu-
ration provides MAC Filtering to the Total Control streaming
components, while freeing up additional ports on the
MFSPOE-8 to connect PoE devices like Keypads and IP
Cameras.
n
An MRX-10 doesn't have to be connected to the MFSPOE-8,
but can be connected to a standard network switch when
convenient to do so.
ETWORK
MFSPOE-8
Attic
S I
WITCH NSTALLATION
Family Room
Office
Page 8
M
ANUAL
Standard Network Switch
MRX-10
SNP-1
DMS-1200
Standard Network Switch
DMS-100