Configuration - Panasonic GTWIN Reference Manual

Menus

The through function is not available during the version upgrade and while
transferring screens.
All Data
Selecting "All Data" only applies to data in this field above the line. When "All Data" is
selected, the other options above the line will be grayed out. You must select any other
options in addition if you wish to transfer such data.
Verify
Use this function to verify that the project you have open in GTWIN corresponds to the project
on the GT unit.
Com Settings
Select [Com Settings] to modify the communication parameters.
Password
You can set a password with up to 8 alphanumeric characters. They are not case sensitive.
You can "unprotect" the GT unit by entering your old password and then leaving the "New
Password" and "Reenter new password" fields blank.
FP Monitor
Use this function to transfer the FP Monitor screens (see p. 80) to the GT unit.
Do not forget your password. If you should forget it, the GT unit's memory must
be cleared entirely.

4.1.6 Configuration

Via File  Configuration, you can configure:

GTWIN (see p. 19)

the GT unit (see p. 21)
Use File  Transfer to selectively transfer the configuration or other data between GTWIN
and the GT unit.
114
GTWIN Reference Manual