Button To Tower Clearance Inspection; Shift Weight Inspection; Bearing Inspection - Polaris 2011 RANGER RZR Service Manual

Button To Tower Clearance Inspection

1. Inspect for any clearance between spider button to tower.
If clearance exists, replace all buttons and inspect surface
of towers. See "Spider Removal" procedure.
Button to Tower Clearance:
000-.005"
2. Inspect sheave surfaces. Replace the entire clutch if worn,
damaged or cracked.

Shift Weight Inspection

WARNING
The clutch assembly is a precisely balanced
unit. Never replace parts with used parts from
another clutch assembly!
1. If clutch is not disassembled, inspect as shown, using a
clutch holding tool to compress the moveable sheave. The
contact surface of the weight should be smooth and free of
dents or gall marks.
9923142 - 2011 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2010 Polaris Sales Inc.
2. Remove shift weight bolts and weights. Inspect the contact
surface of the weight. The surface should be smooth and
free of dents or gall marks. Inspect the weight pivot bore
and pivot bolts for wear or galling. If weights or bolts are
worn or broken, replace in sets of three with new bolts.
NOTE: A damaged shift weight is usually caused by
a damaged or stuck roller in the spider assembly.
See "Roller, Pin and Thrust Washer Inspection".

Bearing Inspection

1. Rotate the clutch bearing in both clockwise and counter-
clockwise directions. The non-braking bearing should
rotate in both directions on the shaft with only a slight
amount of drag.
2. Verify there is no binding or rough spots. If problems are
noted continue with disassembly.
CLUTCHING
6
6.15