Specifications - Shure P4T User Manual

LOOP APPLICATIONS
The LOOP OUT 1/L and 2/R outputs route the transmitter's incoming signal to other devices. Use the loop feature of the transmitter in
any number of applications, such as the following:
MIXER
Operating Floor Monitors Through a P4T Transmitter: Send an audio signal through the LOOP connectors to a floor monitor amplifier.
In this set up, the receiver and the onstage monitors reproduce the same audio.
P4T TRANSMITTER
(BACK PANEL)
MIXER
Making a Recording Through a P4T Transmitter: To record a performance, connect the LOOP outputs to the inputs of a tape deck,
DAT, or other recording device.
BAND MIX
SOLO MIX 1
SOLO MIX 2
MIXING CONSOLE
SOLO MIX 3
Operating Multiple PSM Wireless Systems Under MixMode Control: Send a band mix from a mixer to a P4T transmitter, then send
the band mix on to other transmitters using the P4T's LOOP OUT feature. Also send independent monitor mixes or direct outputs to the
second channel of each transmitter. The entire band receives the same band mix, while each individual player also hears a solo mix of
their own. Use the MixMode control on the P4R receiver to adjust the level between the solo mix and the band mix.
ENGLISH
P4T Transmitter (back panel)
CASSETTE RECORDER
P4T TRANSMITTER
BAND MIX
P4T TRANSMITTER
BAND MIX
P4T TRANSMITTER
Floor Monitor Amplifier
P4R RECEIVER
P4R RECEIVER
P4R RECEIVER
5
P4R
Receiver
SOLO MIX 1
BAND MIX
P4R RECEIVER
SOLO MIX 2
BAND MIX
SOLO MIX 3
BAND MIX