Getting started
Telephone base and charger installation
Install the telephone base and charger, as shown below.
Telephone base installation
•
Plug the other end
of the telephone
line cord into a
telephone jack or
a DSL filter.
•
Raise the antenna.
Charger installation
Telephone line cord
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
The DSL filter must be
plugged into the telephone
wall jack.
Plug the power adapter into a power
outlet not controlled by a wall switch.
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this
product. To order a replacement power adapter, visit
our website at
1 (800) 222-3111
call
1 (866) 288-4268
refer to the online Complete user's manual at
www.telephones.att.com/manuals.
2. The power adapters are intended to be correctly oriented
in a vertical or floor mount position. The prongs are not
designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
www.telephones.att.com
.
For more detailed instructions,
3
•
Plug one end of the
telephone line cord
into the telephone
jack on the back of
the telephone base.
•
Plug the small end of
the telephone base
power adapter into
the power adapter
jack on the back of
the telephone base.
•
Route the power
adapter cord and the
telephone line cord
through this slot.
•
Plug the large end of
the telephone base
power adapter into
a power outlet not
controlled by a wall
switch.
. In Canada, dial
or