Introduction This quick start guide provides you basic installation and use instructions. A limited set of features are described in abbreviated form. Table of contents Telephone installation ........................1 Quick reference guide ........................3 Set date and time ..........................5 Line power mode (no AC power) ....................6 Making and answering a call ......................6 Answering system ..........................8...
Telephone installation If you subscribe to high-speed Internet service (DSL - digital subscriber line) through your telephone line, you must install a DSL filter between the telephone line cord and the telephone wall jack. The filter prevents noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters.
Page 4
Telephone installation Lift the handset or press SPEAKER to check for a dial tone. Rotate the top of the display up or down to adjust the angle of the screen for maximum visibility. NOTES: • Use only the power adapter provided with this product. To obtain a www.telephones.att.com replacement, visit our website at or call...
Quick reference guide REMOVE CID/ While reviewing the call Press to display the call history entries, history. press and hold to clear While using the menu, the call history. press to scroll through While reviewing an the settings. entry stored in the While reviewing the directory or call history, directory or call history,...
Page 6
Quick reference guide MENU Press to enter the RINGER VOL switch menu. Slide to adjust the While reviewing the call ringer volume. history, press to store the displayed name and VOL switch number in the directory. Slide to adjust the listening volume on the MUTE handset.
Set date and time Follow the steps below to set the date and time. Press MENU repeatedly until the screen shows SET TIME/DATE. Press SELECT to show MM/DD/YYYY. Use the dial pad keys (0 through 9) to set the blinking digits. To enter a number that is less than 10, you must enter a zero (0) before the number.
Line power mode (no AC power) This telephone provides minimal functionality during a power failure. When AC power is not available, the screen is blank and many telephone features do not function. Only touch-tone dialing and volume adjustment (ringer volume and handset volume) are supported.
Making and answering a call Using handset To make a call: • Lift the handset, wait for the dial tone, and then dial a number. To answer a call: • Lift the handset. To end a call while using the handset: •...
Answering system Turn the answering system on or off Press ANS ON/OFF repeatedly to turn the • answering system on or off. When the answering system is on, it announces, “Answering machine is on.“ The ANS ON/OFF light is on. When the answering system is off, it announces, “Answering machine is off.“...