Table of Contents
Advertisement
6. Memory & AGP Voltage Adjustment
With our considerate design, you can adjust memory and AGP voltage in BIOS. The
memory voltage range is from 2.5V to 2.8V and the AGP voltage is from 1.5V to 1.65V.
Note: It is risky to adjust those voltages. Please
make sure your Memory and AGP Card support
those new voltages before you doing that.
7. Support USB 2.0 Connector
This motherboard provides six USB 2.0 connectors to connect USB devices, such as
mouse, keyboard, modem, printer, etc. There are four connectors on the back panel. You
can use proper cables to connect the Front USB connector to USB modules or front
panel of chassis.
Pin 1
SBD2+
GND
SBD2-
Key
1
NC
2
GND
SBD3-
SBD3+
USB 2.0 Connector
8. IEEE 1394 Connector
With IEEE1394 MAC Embedded in nForce2-GT/ST (with AGERE FW802A), the IEEE
1394 provides data transfer rate up to 400Mb/s, and USB just has 12Mbps. Hence, the
IEEE 1394 interface can connect with the devices that need high data transferring
performance, such as digital camera, scanner or others IEEE 1394 devices. Please use
the proper cable to connect with devices.
9. TV Output Connector
This motherboard comes with a TV Output connector which allows you to accept digital
graphic input signal, and encodes, and transmit data through DVI or TV Output. Both
NTSC and PAL TV formats are supported for this function. You may just install a TV
Output module (as shown) to your back panel, connect S-Terminal or AV-terminal to your
TV, then use it as your another monitor.
S-Terminal
AV-Terminal
(User Upgrade Optional)
GND
Key
Chroma
2
6
5
1
Composite Video
Luma
GND
Pin 1
+12V(fused)
9
10
SHIELD GND
-12V(fused)
Warning: Please be noted that
Hot-Plug in is not allowed on
IEEE 1394 header, because it will
burn the IC of the controller and
damage the motherboard.
Pin 1
TPB+
GND
TPA+
1
2
TPA-
GND
TPB-
Advertisement
Table of Contents
