Auto Connection - AT&T TL92271 Quick Start Manual

Bluetooth setup
9. The screen displays Adding Headset A to device list...
when the base is connecting to your headset.
0. When a device is successfully connected, the handset
displays Headset A is added and connected to base
and the corresponding status icon ( 1 or
a confirmation tone. The corresponding light on the
telephone base (DEVICE 1 or DEVICE 2) turns on.
If you have trouble pairing your cell phone, it may not
be compatible with your TL92271/TL92371/TL92471.
Check the Bluetooth compatibility list at
www.telephones.att.com
NOTES:
• The pairing process may take up to one minute. If the pairing process fails, try again.
• If you put the handset back in the telephone base or charger while pairing, the process
discontinues and the handset returns to idle mode.
• If a device fails to connect, the handset displays Headset A is added into the device
list, and then displays Please use headset to connect to base.
• When a connected headset is charging, it may disconnect from the telephone base and
the corresponding light on the telephone base (DEVICE 1 or DEVICE 2) turns off. For
some headset models, you may need to turn on the headset and reconnect it to the
telephone base again.

Auto connection

An active device may be disconnected from the telephone base when:
• The Bluetooth feature of your cell phone is turned off.
• The power of your device is turned off.
• Your Bluetooth device is not within range of the telephone base.
When the Bluetooth or power on the device is turned on or it moves within
range of the base, the base will try to reconnect to the Bluetooth device. If
you disconnect the device through the device list, the base will not attempt
to reconnect unless your device is moved out of range and then goes back
in range again.
.
3
2). You hear
Adding
Headset A
to device
list...
1
Headset A
is added
and connected
to base.