Table of Contents
Advertisement
Transmitter Programming:
Notes: Remote Transmitters/Transceivers come pre-programmed from the Factory. When re-learning remotes or adding
remotes, ALL your system's remote codes must be learned at time of programming!! These systems allow storage of up
to 4 different remote codes in memory.
1. Turn Ignition Key to the ON position. (Do not start vehicle).
2. Press Program/Valet button 4 times. Wait for the unit to flash the parking lights and/or honk horn exactly 4 times.
3. Press the Lock button of the first transmitter. You should get 1 light flash confirming the remote is coded, then press
Lock button of a second transmitter, the unit will flash 2 times confirming the remote is coded and so on. If all 4 codes
are learned, the unit will automatically exit code learning mode, otherwise turn key off. See diagram below.
RS1 Only
PRESS
START ONLY
2 VEHICLE OPERATION and PROGRAMMING: Option 29-1 must be selected for 2-Vehicle Mode
To set up the 2 vehicle operation you must have all 4 remotes for programming. For the first vehicle (remotes 1 & 2)
press the Lock as in step 1 thru 3. To change from vehicle 1 to vehicle 2, press the VEH button on remote for about 2
seconds. The LED on remote will change from blue to red.
TRANSMITTER PROGRAMMING
IGN
OFF
RS3 - RS4 - RS7
PRESS
LOCK
PRESS 4X's
FLASH 2, 3, or 4 X's
23
WAIT FOR
4 FLASHES
IGN
OFF
COMPLETE
Hide quick links:
Advertisement
Table of Contents
