Transmitter Programming - CrimeStopper COOLSTART RS-830 Installation Instructions Manual

Transmitter Code Learning:
Notes: Remote Transmitters come pre-programmed from the Factory. When re-learning remotes or adding remotes,
ALL your system's remote codes must be learned at time of programming!! These systems allow storage of up to 4
different remote codes in memory. Antenna / Receiver must be plugged into unit.
1. Open hood (ground the Gray hood pin wire if no hood pin is installed.)
2. Turn key to the ON position. (Do not start vehicle)
3. Press Program/Valet button 4 times. After a few seconds, the unit will flash the parking lights 4 times.
4. RS-830: Press Button #1 (Lock) of the transmitter to be learned. RS-810 Model: Press Engine Start button. You
should get 2 light flashes indicating the code-learn. Now the unit is waiting for a 2
needed with up to 3 additional remotes. The unit will flash the lights in succession after each code learned for up to 4
codes. (2 flashes for the 2
exit code learning mode, otherwise turn key OFF and close the hood. (See Diagram Below)
(GRAY WIRE GROUNDED)
RS-830
PRESS
LOCK BUTTON
RS-830/810 TRANSMITTER CODE LEARNING
nd
code, 3 flashes for the 3
OFF
RS-810
PRESS
START BUTTON
rd
code etc.) If all 4 codes are learned, the unit will automatically
IGN
PRESS 4X's
FLASH 2, 3, or 4 X's
16
nd
code, so repeat this step as
WAIT FOR
4 FLASHES
IGN
OFF
COMPLETE