Advertisement
HOW TO USE THE TIMER
To program heating, proceed as follows:
-
Look at the time on your clock or watch. If it is 10 p.m., turn the numbered timer disk clockwise until the number
10 p.m. on the disk coincides with the pointer L (2) on the timer. Set the periods of time when you want the
appliance to work by pushing the teeth (1) inwards. Each tooth (1) corresponds to a period of 15 minutes. This will
leave visible sectors which correspond to the periods of operation (3). When set, the radiator will operate automati-
cally each day during the times programmed (important: the radiator must always be plugged into the socket).
-
To change the programming, move the teeth back into the initial position and set the new periods of functioning.
-
If you want to make the appliance operate without programming, push all the teeth into the centre. In this case, to
turn the appliance off completely, as well as turning the knob to the off position, you must also unplug it from the
mains to avoid continued operation of the timer.
A safety device
The appliance is fitted with a safety device that will switch it off in case of accidental overheating. To reset, disconnect the
plug from the power for 30 minutes, remove the cause of overheating, then plug the appliance in again.
6. MAINTENANCE AND SERVICE
Always unplug the heater from the power outlet and allow the radiator to cool. Wipe radiator with a soft damp cloth; do
not use detergents and abrasives.
Should the radiator not be in use over a certain length of time, roll the cable around the holder and store it in a dry place.
This appliance has been built to last for many years of trouble-free service.
In case of malfunction or doubt, do not try to repair the heater by yourself: this might increase the risk of fire and electric
shock.
Call your nearest Service Centre (see attached list of Service Centre).
1
3
2
5
Advertisement
