Voice Command - Dodge 2010 Avenger User Manual

Receiving A Call – Accept (And End)
• When an incoming call rings/is announced on Uconnect™, press the Phone
button .
• To end a call, press the Phone button
Mute (Or Unmute) Microphone During Call
• During a call, press the Voice Command button
• (After the BEEP), say "mute on" (or "mute off").
Transfer Ongoing Call Between Handset And Vehicle
• During a call, press the Voice Command button
• (After the BEEP), say "transfer call".
Changing The Volume
• Start a dialogue by pressing the Phone button
normal call.
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level
while the Uconnect™ system is speaking. Please note the volume setting for
Uconnect™ is different than the audio system.
NOTE: To access the tutorial, press the Uconnect™ hard-key. After the BEEP, say
"tutorial". Press any hard-key or touch the display to cancel the tutorial.

VOICE COMMAND

• The Voice Command system allows you to control your AM, FM radio, satellite radio,
disc player, Uconnect™ Phone and a memo recorder. When you press the Voice
Command button
command. If you do not say a command within a few seconds, the system will present
you with a list of options. If you ever wish to interrupt the system while it lists options,
press the Voice Command button
• For vehicles equipped with Video Entertainment System (VES)™, refer to the Voice
Command section of the Uconnect™ User's Manual on the DVD for further details.
• For vehicles not equipped with VES™, refer to your vehicle Owner's Manual on the
DVD for Voice Command information.
.
, you will hear a beep. The beep is your signal to give a
, listen for the BEEP, and say your command.
35
ELECTRONICS
.
.
, then adjust the volume during a