Noise After Filling The Ink; Software Installation Problems; Solving Network Problems - Epson M200 User Manual

Noise After Filling the Ink

If you hear noises from your product after filling the ink tank with ink, check these explanations:
• The first time you fill the tank with ink, the product must charge its print head. Wait until charging
finishes before you turn off the product, or it may charge improperly and use excess ink the next time
you turn it on. Your product is finished charging the print head when the
• If the product's print head stops moving or making noise, and the charging process has not finished,
turn off your product. Turn it back on and check to see if charging is still in progress. If it is still in
progress, contact Epson for help.
Parent topic:
Related concepts
When to Uninstall Your Product Software
Related references
Windows System Requirements
OS X System Requirements
Related topics
Refilling Ink

Software Installation Problems

If you have problems while installing your product software, try these solutions:
• Make sure your product is turned on and any necessary cables are securely connected at both ends. If
you still have problems installing software, disconnect the cable and carefully follow the instructions on
the Start Here sheet. Also make sure your system meets the requirements for your operating system.
• Close any other programs, including screen savers and virus protection software, and install your
product software again.
• In Windows, make sure your product is selected as the default printer and the correct port is shown in
the printer properties.
• If you see any error message or your software does not install correctly in Windows, you may not have
software installation privileges. Contact your System Administrator.
Parent topic:

Solving Network Problems

Check these solutions if you have problems setting up or using your product on a network.
Solving Setup Problems
Solving Setup Problems
146
power light stops flashing.