Table of Contents
Advertisement
RECALL" appears on the display. Pressing SET when this message is on the
display recalls the text that was on the screen when you last turned off
power.
∑
Pressing any key besides SET, FUNC, SHIFT or CODE clears the text from
memory.
Resetting the Memory
You should reset the memory of the label printer before using it for the first
time, after you have not used it for a long time, or if nothing happens when
you turn power on.
Important! Resetting label printer memory clears its memory of all input data.
To reset the memory
1.
Make sure that label printer power is off.
2.
While holding down the PRINT and ESC keys, press ON to turn power on.
3.
Press SET to initialize the label printer or ESC to abort the reset
operation without initializing anything.
∑
See "Initial Settings" on page E-24 for information on the initial
default settings of the label printer following the reset operation.
∑
You have to reset the Label Printer if you want to change the on-screen
message language. Press RESET and then perform the procedure performed under
Message Language.
Auto Power Off Function
If you do not perform any key operation for about six minutes, the label
printer automatically turns power off. To restore power, press ON.
Tape Cartridges
Use the procedures described below to load a tape cartridge into the label
printer. The label printer automatically detects what size tape is loaded.
Important! Never try to push the tape back into the cassette. Once tape is out
of the cassette, there is no way to wind it back in. Trying to do so can cause
operational problems with the label printer.
To load a tape cartridge
1.
Make sure the label printer is turned off.
2.
Press the cover release and open the cover.
∑
If there is a cartridge already in the label printer, remove it by
grasping the cartridge on both sides with your thumb and forefinger, and lift
straight up.
3.
Remove the stopper from a new tape cartridge and check to see that the
tape is ready to use.
4.
Check to make sure that the end of the tape is not bent.
∑
If the end of the tape is bent, use scissors to cut off the bent
portion.
5.
Make sure that the tape is under the tape guide and that it is not bent
or twisted.
∑
Make sure the end of the tape is passing through the tape guide. If it
isn't, pass the end of the tape through the tape guide as shown in the
illustration.
6.
Pull out about 3cm (11/8") of tape.
∑
Never try to force tape back into the cartridge once it is pulled out.
∑
Do not pull on the tape too hard. Doing so can break the ink ribbon and
result in malfunction.
Advertisement
Table of Contents
