Remove The Function Pcb With The Rear Panel Attached To It - Yamaha RX-Z9 Service Manual

#5
h. Remove 2 screws ( ) and 3 screws (
remove the Frame (CNT-L). (Fig. 14, 15)
#7
i. Remove 2 screws ( ) and 3 screws (
remove the Frame (CNT-R). (Fig. 14, 15)
#9
j. Remove 3 screws ( ) and 2 screws (
k. Disconnect the following connectors.
l. Remove the FUNCTION P.C.B. with the Rear Panel (Up-
per) attached to it. (Fig. 14)
CAUTION
The FUNCTION P.C.B. has many wires connected internally on
both the top and the back faces. Be careful not to change rout-
ing of these wires. (The hum level may vary when their routing
is changed.)
#6 #5
) and then
#8 #7
) and then
$0 #9
). (Fig. 14, 15)
Fig. 16
Fig. 17
RX-Z9/DSP-Z9
#6
#8
$0
23