TransmTtNg A Call - Icom IC-F5060 series Operating Manual

■ Transmitting a call
IDAS operaton allows you to make a call to a specfic staton
(Indvdual call) or to a partcular group (Talkgroup call). Other
dgtal mode transcevers on the channel wll not receve a
call that does not match ther ndvdual or talkgroup ID and/or
RAN (Rado Access Number) code.
D Transmitting a Voice Call
q Push [Digital Button] to enter the applcaton selecton
mode.
• "VOICE" appears.
• To change the call type, push and hold [Digital Button] for 1 sec.
durng stand-by operaton. After changng, the transcever enters
the applcaton selecton mode automatcally.
I N D I V I D U A L
V O I C E
* This illustration is described with Individual call type.
w Push [Digital Button] agan to enter the Indvdual or Talk-
group ID selecton mode.
• The pre-programmed ID name s dsplayed.
• When ID name s not programmed, ID code s dsplayed.
• The prmarly ID can be pre-set to dsplay frst.
Ths functon s usable n transcevers whose revson number s
2.9 or later. Ask your dealer for detals.
• When you want to send a voce message to all transcevers
wthn the communcaton range, use the 'All Call' functon–— se-
lect the Talkgroup ID code "65535".
e Push [CH Up] or [CH Down] to select the desred ID name
(or ID code).
• Dependng on the pre-settng, you can nput the ID drectly. (The
optonal HM-152T s requred.) See p. 41 for detals.
V O I C E
S T A T I O N
Individual or Talkgroup
ID name is displayed.
r Push and hold [PTT], then speak nto the mcrophone to
send a voce message to the selected staton or talkgroup.
t Release [PTT] to receve.
Convenient! (The optonal HM-152T s requred.)
Dependng on the pre-settng, you can use the quck ID selec-
ton for the Voce Call.
➥ Whle n the stand-by condton, push the desred dgt key
([1] to [9] or [0]) to enter the ID selecton mode.
• The approprate ID s dsplayed.
5
IDAS OPERATION
1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
30