Cable Adjustment; Assembling The Cutting Equipment - Jonsered BP2053 Operator's Manual

7 Bind the throttle cable (J) and the flexible shaft (K) with
two bands (L).

Cable adjustment

• The throttle cable should be paralleled to the flexible shaft.
In case of twisting, they should be restored by parallel.
• The throttle cable should be adjusted under the bent
flexible shaft as shown.
1 Adjust the cable adjuster sleeve so the stop on the
carburettor throttle cam just contacts the throttle stop and
the cable position keep 1-2 mm play between the cable
lug and the slotted fitting when the throttle trigger is fully
depressed.
1-2mm
2 When the throttle cable is adjusted correctly, tighten the
lock-nut (G).

Assembling the cutting equipment

WARNING!
!
When fitting the cutting attachment it is
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.
WARNING! Never use a cutting attachment
!
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
12 –
English
ASSEMBLY
Fitting the cord cutter and guard extension
to the trimmer guard
• Attach the cord cutter to the guard extension with screw
and square nut as shown.
• Fit the guard extension to the trimmer guard as shown.
Fitting a blade guard, grass blade and
grass cutter
• Fit the guard (A) to the gear housing using the support
plate (M) and two screws (L).
B
M
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Place the blade (D), support cup (E) and support flange
(F) on the output shaft.
• Fit the nut (G). The nut must be tightened to a torque of
35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool
kit. Hold the shaft of the spanner as close to the blade
L
C
A