Travis Industries GreenSmart 564 SS Installation Manual page 69

Optional Equipment
18 Pull the "RECEIVER" connector through the control panel and attach to the receiver (see Figure
27). Then attach the receiver to the control panel with the two #8 machine screws (see Figure
28).
19 Place batteries into the receiver and transmitter (see Figure 29). Calibrate the receiver to the
transmitter (see Figure 30 - use a paperclip to press the "PRG" button, let it beep, then press any
button on the transmitter – the receiver should beep 5 times – see the operating instructions for
further details).
20 Place the receiver coverplate (and switch) over the receiver (see Figure 31) and attach with the
two screws included with the receiver (see Figure 32)
© Travis Industries
(for qualified installers only)
Figure 27
Figure 29
4081126
69
Figure 28
Figure 30
100-01210_000