Wiring - Kenmore 153.326164 Use & Care Manual

8. Tighten terminals 2 and 3 to ensure proper electrical
connection.
Fire and Explosion Hazard
" Failure to tighten screws can
cause a fire.
,, Failure to do this could result in
death, serious bodily injury, or
property damage.
11. Replace the access panel.
I
<
I
FIGURE 21.
12. Complete wiring to the water heater, or if completed, turn
"ON" electric power to the water heater after filling the tank
with water.
Failure to tighten terminal screws can cause a fire which can
result in DEATH, SERIOUS BODILY INJURY, OR PROPERTY
DAMAGE.
9. Replace terminal cover on thermostat making sure that the
locking tabs on the terminal cover are in place.
Fire and Explosion Hazard
,, Thermostat must be flush
against the tank.
,, Make sure terminal cover is in
place and the insulation
replaced.
,, Failure to do this could result in
death, serious bodily injury, or
property damage.
Make sure the thermostat is flush against the tank, the terminal
cover is in place, and the insulation is replaced. Failure to
do so can result in DEATH, SERIOUS BODILY INJURY, OR
PROPERTY DAMAGE.
10. Replace the insulation so that it completely covers the
thermostat and element.
FIGURE 20.
1
FIGURE 22.
Improper installation and use may result
in property damage.
• Fill tank with water before operation.
Never use this water heater unless it is completely full of water.
To prevent damage to the tank and heating element, the tank
must be filled with water. Water must flow from the hot water
faucet before turning on power.
Wiring
Fire Hazard / Electric Shock Hazard
15
Do not use this water heater with
any voltage other than shown on the
model rating plate.
Failure to use the correct voltage
shown on the model rating plate
could result in death, serious bodily
injury, or property damage.
You must provide all wiring of the proper size outside of the
water heater. You must obey local codes and electric company
requirements when you install this wiring.