Normal Playback; Preparing For Playback; Listening To A Source Component - Kenwood VR-510 Instruction Manual

Normal playback

Preparing for playback

24
Some preparatory steps are needed before starting playback.
POWER ( )
SPEAKERS A/B
Selecting the input mode
If you have selected a component connected to the CD/DVD, DVD/6ch,
VIDEO2, or VIDEO3 jacks, make sure that the input mode setting is
correct for the type of audio signal to be used.
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is "TAPE". To change the
source to "MD", follow the steps below:
1 Use the INPUT SELECTOR knob to select "MD/TAPE".
2 Hold down the AUTO key for more than 2 seconds.
• The source indication changes to "MD".
• To return to the original indication, repeat procedure 2.
Selecting the speaker system
Press the SPEAKERS A or B key to select the speaker system to
be used.
A ON : Sound from the speakers connected to the SPEAKERS A
terminals on the rear panel.
B ON : Sound from the speakers connected to the SPEAKERS B
terminals on the rear panel. No sound will be heard from the
subwoofer.
A+B ON : Sound from both the speakers connected to the SPEAKERS
A and B terminals on the rear panel.
A+B OFF : No sound from the speakers. Use this setting when listening
with headphones for stereo sound in all playback modes.
The indicator for the speakers
you want to use should be lit.
SP
CLIP
RDS EON
TP
• Selecting "6ch INPT" by pressing the INPUT MODE key, whereby
"DVD/6ch" is the input source will cause SPEAKERS A to be selected
automatically.
• When you use the PRE OUT jacks, set only SPEAKERS A to ON
mode.
Turning on the receiver
1 Turn on the power to the related components.
2 Turn on the power to this receiver by pressing POWER (
or SYS. POWER (
INPUT MODE
AUTO/CINEMA EQ.
INPUT SELECTOR
A B TI.VOL
L C R
MUTE
LFE SW
PTY
LS S RS
TA NEWS
) key.

Listening to a source component

7
1
Use the INPUT SELECTOR knob, MUSIC key, or MOVIE key
to select the source you want to listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
1 "PHONO"
2 "TUNER"
3 "CD/DVD"
4 "TAPE" or "MD"
5 "VIDEO1"
6 "VIDEO2"
7 "VIDEO3"
8 "DVD/6ch"
9 "AV AUX"
Selecting a source using the MUSIC key
1 "CD/DVD"
2 "TAPE" or "MD"
3 "TUNER"
4 "PHONO"
Selecting a source using the MOVIE key
1 "VIDEO1"
2 "VIDEO2"
3 "VIDEO3"
4 "DVD/6ch"
5 "AV AUX"
• MUSIC and MOVIE will not display input sources which are not
pre-setup.
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or VOL. +/– keys to
adjust the volume.
)
VOLUME CONTROL
INPUT SELECTOR
MUSIC
MOVIE
VOL.