Specifications - Kenwood VR-510 Instruction Manual

Specifications

AUDIO section
Rated power output during STEREO operation
110 watts per channel minimum RMS, both channels driven, at
8 Ω from 20 Hz to 20 kHz with no more than 0.7% total harmonic
distortion. (FTC)
Effective power output during SURROUND operation
FRONT (20-20kHz, 0.7% T.H.D. at 8 Ω one channel driven)
.............................................................................. 110 W + 110 W
CENTER (20-20kHz, 0.7% T.H.D. at 8 Ω one channel driven)
............................................................................................. 110 W
SURROUND (20-20kHz, 0.7% T.H.D. at 8 Ω one channel
driven) .................................................................. 110 W + 110 W
Total harmonic distortion ......................... 0.045% (1 kHz, 55W, 8 Ω)
Frequency response
CD ............................................. 10 Hz ~ 60 kHz, +0 dB, –3.0 dB
Signal to noise ratio (IHF'66)
PHONO (MM) ........................................................................ 75 dB
CD ......................................................................................... 92 dB
Input sensitivity / impedance
PHONO (MM) ............................................................ 4 mV / 27 kΩ
CD ......................................................................... 300 mV / 47 kΩ
MONITOR IN ........................................................ 300 mV / 47 kΩ
DVD/6CH INPUT .................................................. 300 mV / 47 kΩ
Output level / impedance
TAPE REC .............................................................. 300 mV / 1 kΩ
MONITOR OUT ...................................................... 300 mV / 1 kΩ
PRE OUT (FRONT, CENTER, SURROUND) ............. 1 V / 500 Ω
PRE OUT (SUBWOOFER) ....................................... 1.8 V / 500 Ω
Tone control
BASS ................................................................ ±10 dB (at 70 Hz)
TREBLE .......................................................... ±10 dB (at 10 kHz)
DIGITAL AUDIO section
Sampling frequency ...................... 32 kHz, 44.1 kHz, 48 kHz, 96kHz
Input level / impedance / wave length
Optical ........................... (–15 dBm ~ –21 dBm), 660 nm ±30nm
Coaxial ................................................................. 0.5 Vp-p / 75 Ω
Notes
1. KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
2. The full performance may not be exhibited in an extremely cold location (under a water-freezing temperature).
Caution : Read this page carefully to ensure safe
operation.
VIDEO section
VIDEO inputs / outputs
(composite) ............................................ 1 Vp-p / 75 Ω
VIDEO
S VIDEO (luminance signal) ................................ 1 Vp-p / 75 Ω
(chrominance signal) ..................... 0.286 Vp-p / 75 Ω
COMPONENT VIDEO (luminance signal) ............. 1 Vp-p / 75 Ω
(C /C
B
FM tuner section
Tuning frequency range ................................... 87.5 MHz ~ 108 MHz
Usable sensitivity (MONO)
................ 1.3 µV (75 Ω)/ 13.2 dBf (75 kHz DEV., SINAD 30 dB)
50dB quieting sensitivity
STEREO ................................................... 28 µV (75 Ω)/ 40.2 dBf
Total harmonic distortion (1 kHz)
MONO ............................................................ 0.5% (65 dBf input)
STEREO ........................................................ 0.7% (65 dBf input)
Signal to noise ratio (1 kHz, 75 kHz DEV.)
MONO .......................................................... 75 dB (65 dBf input)
STEREO ...................................................... 68 dB (65 dBf input)
Stereo separation (1 kHz) .......................................................... 40 dB
Selectivity (±400 kHz) ................................................................. 70 dB
Frequency response ................. (30 Hz ~ 15kHz), +0.5 dB, –3.0 dB
AM tuner section
Tuning frequency range
10 kHz step ................................................. 530 kHz ~ 1,700 kHz
Usable sensitivity ................................................. 16 µV / (600 µV/m)
Signal to noise ratio (30% mod. 1 mV input) ........................... 50 dB
GENERAL
Power consumption .................................................................... 2.6 A
AC outlet
SWITCHED ....................................... (total 150 W, 1.25 A max.)
Dimensions ..................................................... W : 440 mm (17-5/16")
Weight (Net) .............................................................. 8.75 kg (19.3 lb)
- signal) ....... +/– 0.324 Vp-p / 75 Ω
R
H : 144 mm (5-11/16")
D : 399 mm(15-11/16")
51